For the sport of soaring in gliders (sailplanes), see Gliding.
Gliding flight is heavier-than-air flight without the use of thrust. It is employed by gliding animals and by aircraft such as gliders. The most common human application of gliding flight is in sport and recreation using aircraft designed for this purpose. However almost all powered aircraft are capable of gliding without engine power. As with sustained flight, gliding generally requires the application of an airfoil, such as the wings on aircraft or birds, or the gliding membrane on gliding possum. However, gliding can be achieved with a flat (uncambered) wing as with a simple paper plane, or even with card-throwing. The term volplaning has been used for this mode of flight.
1 Instances of gliding flight
1.1 Aircraft ("gliders"),
3 Lift to drag ratio,
5 Glide ratio,
7 Importance of the glide ratio in gliding flight,
10 See also,
Instances of gliding flight:
Main article: http://en.wikipedia.org/wiki/Glider_aircraft
Most winged aircraft can glide to some extent, but there are several types of aircraft designed to glide:
Glider, also known as a sailplane,
Rotor kite, if untethered, known as a rotary glider, or gyroglider.,
The main human application is currently recreational, though during the Second World War military gliders were used for carrying troops and equipment into battle. The types of aircraft that are used for sport and recreation are classified as gliders (sailplanes), hang gliders and paragliders. These two latter types are often foot-launched. The design of all three types enables them to repeatedly climb using rising air and then to glide before finding the next source of lift. When done in gliders (sailplanes), the sport is known as gliding and sometimes as soaring. For foot-launched aircraft, it is known as hang gliding and paragliding. Radio-controlled gliders with fixed wings are also soared by enthusiasts.
In addition to motor gliders, some powered aircraft are designed for routine glides during part of their flight; usually when landing after a period of a powered flight. These include:
Experimental aircraft such as the North American X-15, which glided back having used their fuel,
Spacecraft such as the Space Shuttles, SpaceShipOne and the Russian Buran,
Some aircraft are not primarily designed to glide except in an emergency, for example airliners that have run out of fuel. See list List of airline flights that required gliding flight.
Further information: Flying and gliding animals and List of soaring birds
A number of animals have separately evolved gliding many times, without any single ancestor. Birds in particular use gliding flight to minimise their use of energy. Large birds are notably adept at gliding, including:
Like recreational aircraft, they too can alternate periods of gliding with periods of soaring in rising air, and so spend a considerable time airborne with a minimal expenditure of energy. For similar reasons to birds, bats can glide efficiently.
Other mammals such as gliding possums and flying squirrels also glide, but with much poorer efficiency than birds and cannot gain height. For these creatures, gliding has mainly evolved to get from tree to tree in rainforests, most especially Borneo, where the trees are tall and widely spaced. This mode of flight involves flying a greater distance horizontally than vertically and is therefore can be distinguished from a simple descent like a parachute. Some reptiles, amphibians, flying squid and flying fish also glide.
Three principal forces act on aircraft and animals when gliding:
weight - gravity acts in the downwards direction,
lift - acts perpendicularly to the vector representing airspeed,
drag - acts parallel to the vector representing the airspeed,
As the aircraft or animal descends, the air moving over the wings generates lift. The lift force acts slightly forward of vertical because it is created at right angles to the airflow which comes from slightly below as the glider descends, see angle of attack. This horizontal component of lift is enough to overcome drag and allows the glider to accelerate forward. Even though the weight causes the aircraft to descend, if the air is rising faster than the sink rate, there will be a gain of altitude.
Lift to drag ratio:
Main article: http://en.wikipedia.org/wiki/Lift_to_drag_ratio
The lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving through the air. A higher or more favourable L/D ratio is typically one of the major goals in aircraft design; since a particular aircraft's needed lift is set by its weight, delivering that lift with lower drag leads directly to better fuel economy and climb performance.
The effect of airspeed on the rate of descent can be depicted by a polar curve. These curves show the airspeed where minimum sink can be achieved and the airspeed with the best L/D ratio. The curve is an inverted U-shape. As speeds reduce the amount of lift falls rapidly around the stalling speed. The peak of the 'U' is at minimum drag.
As lift and drag are both proportional to the coefficient or Lift and Drag respectively multiplied by the same factor (1/2mvS), the L/D ratio can be simplified to the Coefficient of lift divided by the coefficient of drag or Cl/Cd, and since both are proportional to the airspeed, the ratio of L/D or Cl/Cd is then typically plotted against angle of attack.
Induced drag is caused by the generation of lift by the wing. Lift generated by a wing is perpendicular to the wing, but since wings typically fly at some small angle of attack, this means that a component of the force is directed to the rear. The rearward component of this force is seen as drag. At low speeds an aircraft has to generate lift with a higher angle of attack, thereby leading to greater induced drag. This term dominates the low-speed side of the drag graph, the left side of the U.
Profile drag is caused by air hitting the wing, and other parts of the aircraft. This form of drag, also known as wind resistance, varies with the square of speed (see drag equation). For this reason profile drag is more pronounced at higher speeds, forming the right side of the drag graph's U shape. Profile drag is lowered primarily by reducing cross section and streamlining.
As lift increases steadily until the critical angle, it is normally the point where the combined drag is at its lowest, that the wing or aircraft is performing at its best L/D.
Designers will typically select a wing design which produces an L/D peak at the chosen cruising speed for a powered fixed-wing aircraft, thereby maximizing economy. Like all things in aeronautical engineering, the lift-to-drag ratio is not the only consideration for wing design. Performance at high angle of attack and a gentle stall are also important.
Minimising drag is of particular interest in the design and operation of high performance glider (sailplane)s, the largest of which can have glide ratios approaching 60 to 1, though many others have a lower performance; 25:1 being considered adequate for training use.
When flown at a constant speed in still air a glider moves forwards a certain distance for a certain distance downwards. The ratio of the distance forwards to downwards is called the glide ratio. The glide ratio (E) is numerically equal to the Lift-to-drag ratio under these conditions; but is not necessarily equal during other manoeuvres, especially if speed is not constant. A glider's glide ratio varies with airspeed, but there is a maximum value which is frequently quoted. Glide ratio usually varies little with vehicle loading however, a heavier vehicle glides faster, but maintains its glide ratio.
Glide ratio (or "finesse") is the cotangent of the downward angle, the glide angle (γ). Alternatively it is also the forward speed divided by sink speed (unpowered aircraft):
Glide number (ε) is the reciprocal of glide ratio but sometime it's confused.
L/D ratio / Glide ratio
45-70 (depending on span)
Boeing 767-200 with fuel exhaustion
high performance model
Northern flying squirrel
Importance of the glide ratio in gliding flight:
Although the best glide ratio is important when measuring the performance of a gliding aircraft, its glide ratio at a range of speeds also determines its success (see article on gliding).
Pilots sometimes fly at the aircraft's best L/D by precisely controlling airspeed and smoothly operating the controls to reduce drag. However the strength of the likely next lift and the strength of the wind also affects the optimal speed to fly. To achieve higher speed across country, gliders (sailplanes) are often loaded with water ballast to increase the airspeed and so reach the next area of lift sooner. This has little effect on the glide angle but increases rate of sink (and speed over ground in proportion) because the heavier aircraft achieves optimal L/D at a higher airspeed.
If the air is rising faster than the rate of sink, the aircraft will climb. At lower speeds an aircraft may have a worse glide ratio but it will also have a lower rate of sink. A low airspeed also improves its ability to turn tightly in centre of the rising air where the rate of ascent is greatest. A sink rate of approximately 1.0 m/s is the most that a practical hang glider or paraglider could have before it would limit the occasions that a climb was possible to only when there was strongly rising air. Gliders (sailplanes) have minimum sink rates of between 0.4 and 0.6 m/s depending on the class. Aircraft such as airliners may have a better glide ratio than a hang glider, but would rarely be able to thermal because of their much higher forward speed and their much higher sink rate. (Note that the Boeing 767 in the Gimli Glider incident achieved a glide ratio of only 12:1.)
During landing, a high lift/drag ratio is desirable. Some aircraft therefore employ flaps, to increase their performance at lower speeds. Experiments with lifting bodies show that a lift/drag ratio below about 2 makes landing very difficult because of the high rate of descent.
The loss of height can be measured at several speeds and plotted on a "polar curve" to calculate the best speed to fly in various conditions, such as when flying into wind or when in sinking air. Other polar curves can be measured after loading the glider with water ballast. As mass increases, the best glide ratio is achieved at higher speeds. (The glide ratio is not increased.)
Main article: http://en.wikipedia.org/wiki/Lift_(soaring)
Soaring animals and aircraft may alternate glides with periods of soaring in rising air. Five principal types of lift are used:thermals, ridge lift, lee waves, convergences and dynamic soaring. Dynamic soaring is used predominately by birds, and some model aircraft, though it has also been achieved on rare occasions by piloted aircraft.
Examples of soaring flight by birds are the use of:
Thermals and convergences by raptors such as vultures,
Ridge lift by gulls near cliffs,
Wave lift by migrating birds,
Dynamic effects near the surface of the sea by albatrosses,
For humans, soaring is the basis for three air sports: gliding, hang gliding and paragliding.
Text from this biography licensed under creative commons license